真ん中3秒押しでblueLED点灯スイッチオン

真中&右3秒押しでスイッチOFF

VOL+

VOL−

あちゃ、読んじゃいましたか・・・
いちすすどんの記憶は数日しか保たないための備忘録でしたm(__)m

FULL充電5時間で使用可能はどれくらいなんだろう?

日本語すら危ういのにあちゃらの言語など・・・
Pairing with Bluetooth devices
Your Midland BT2 is a Bluetooth unit that can be paired with
other Bluetooth devices.
Before performing this procedure, it is necessary to set BT2
into “Pairing mode” (Setup).
The only operations permitted in this mode are the pairing
ones. To use the BT2 unit after pairing it with the desired devices,
it is necessary to quit the “Setup” mode and switch to the
“Operating” mode.
Setup mode
Switch off the BT2 device. Press and hold down the central
button (Intercom/on) for about 7 sec. until the red indicator
switches on permanently. BT2 is now in “Setup” mode and can
therefore be paired with other devices.
Pairing the unit with another BT2 unit
The two units supplied in the Midland BT2-D Intercom
DUAL kit, are already paired and ready for use, which
means that it is not necessary to perform this procedure.
If the devices are not part of the same kit, or one of the BT2
units has been purchased separately, you need to pair them in
order to be able to use the Intercom function.
Place both BT2 units in Setup mode (red indicator permanently
on) Press the “Volume +” button on the first unit until the
RED and BLUE lights begin to flash rapidly and alternately.
Then press the “Volume –“button on the second unit until the
RED and BLUE lights begin to flash rapidly and alternately.
Now both BT2 units are trying to pair to each other.
When successfully paired, each device will light the BLUE light
for 1 sec and go back to setting mode (red light always on)
waiting for additional pairing or setting procedures.
どのメーカーでもOKなのかな〜?
出番ですよ〜〜。
と、呼んでみよう。








0